Idea is so desolder them, then pull the board up, leaving relays and varistor in the epoxy underneath.ģ. There is a lot of epoxy under the PCB and you wont be able to pull the board up with relays and varistor attached. De-solder 2 relays and a varistor, make sure pins wiggle freely inside the vias (relay pins, varistor pins, double check with a needle nose). its actually pretty easy and it comes off in big chunks once you have it heated up to higher temperature. Scrape the upper layer of epoxy to expose the PCB Its quite easy if you have basic electronics knowledge and know how to solder.ġ. So i decided to give it a go since i had nothing to loose. TrimFix only gives you 4 positions for the gauge, and its over $150 shipped (im from Canada)īut i haven't seen anything about actually fixing the original module. Well there is lots of information about the TrimFix module and/or cheap relay bypass fix. Nozzle would 'unscrew' in the lowest position and would not come back up without physical help. Unfortunately this disabled the gauge and limit stops were not active. Previous owner ended up cutting all the wires off the module and wiring his cheap relay fix. So i picked up my first seadoo, turned out vts was busted.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |